Skip to main content

Keep drilling!

Image
By

 Keep drilling every night, making something for the armature’s Jiggs. 

Finally, I found a mass-produced ball joint jig. That was very simple. 


Drilled 2.5mm holes in the 2-layer 2mm thick brass plates with a jig for correct drilling.  

After drilling with a jig, one plate was tapped for a 3mm screw, and another plate drilling with a 3mm bit.

Screwed both plates and drilled 3.5mm holes for the 6mn ball joint, and 5mm holes for the 8mm ball joint. 

Cut them apart off with the band-saw and grind 4 corners. 


Majored and cut a long thread bolt for armature size. 

I forgot to make the neck part. That's why he doesn't have an upper shoulder body. 

Look like he is Rodin’s “Thinker”  He might think something sitting on the band saw that had made him. 

Now we can make an armature original size. 

One bad thing happened a while ago when I tapped a brass block, my only 4mm tap was broken. 

Need to get a new one sometime…

Comments

Post a Comment

Popular posts from this blog

Scale Model and Silicone Mold ver.2

By
Our test shoot went reasonably well, so we've been hard at work creating assets ever since. Recently, we welcomed a graduate of Tokyo University of the Arts as a member. It's very encouraging. However, since we are still a small team, it is inevitable that each person will have to handle multiple tasks at once. Currently I am making two scale models of kayaks, one for normal shooting and one for "distant view". Additionally, I am reworking the default mold for the main character. It is possible to mass-produce faces using the molds I made previously, but I didn't like them because they looked too distorted. This remake was a good experience for me in terms of getting used to working with silicone.  As for our future plans, once the main character is complete, I would like to do some more test shooting. I'm sure we'll be able to see some expressions there. I'm really looking forward to it. You may think that the production process is slow. But I'm n...
Post a Comment
Read more

Molding

By
Hello everyone. It's been quite a while since my last post. So sorry. For the past few months, I've been having trouble creating a "mold" for a character's face. In the end, it turned out as shown in the image, but I'm sure we'll encounter some difficulties as we continue working on it. However, I think that even this is part of the charm of stop-motion animation, right? 😁
Post a Comment
Read more

Qajaq Scale Model

By
Hi there, As previously mentioned, the main characters of this animation are child kayaker, so of course, kayak appear in the play. He carries it, paddles it, and rolls it too. I am building this scale model of a kayak as close to the actual process as possible. The parts are so small that it's quite difficult to work with. However, I believe that the challenges faced in "craftsmanship" are part of the joy, so I welcome these kinds of challenges. I might make scale models in several scales depending on each scene. Yes, it's relatively easy to arrange the materials and tools required. If you have a short holiday, give it a try. By the way, the tools I prepared are a model saw, a pin vise, wood glue, a needle and thread. I will eventually wrap this frame in fabric. I'm still thinking about the fabric. Usually, when Greenland Kayaks are wrapped in fabric or leather, the beauty of the frame is hidden, but in this animation I want to show the beauty of the frame, so I ...
Post a Comment
Read more